Steam Dreams writes:
I’m rebuilding a 20 HP Stanley engine. The block was apparently operated with too
little steam oil and the valve seats were damaged as well as a bronze repair was attempted with poor results.
This repair of the worn valve seats uses a machined steel plate and high temperature silver solder - very pleased with the results. Gilbert Hall and Rempco did the work. My crank gear also had a broken tooth, I had a NOS gear that was pressed on.
For instructions on how to add to our community's blog post, please visit our Get Involved page by clicking on the link above!
Steam Car Network functions as a resource for all steam car and steam bike enthusiasts. The website is constantly updated with articles, events, and informative posts to keep the community alive and growing. Feel free to contact us if you have any questions or concerns at the email address below and we will promptly reply.