Bill Barnes writes:
Drilling and Tapping a Stanley Boiler.
By code you shouldn't drill into the weld ..
As shown in pictures
I try to stay away from the tubes as much as possible..
You run the pipe tap in a little over half way on the tap and check it to your fittings .
I never use bronze or copper fittings in the boiler..
Steel on steel is the best ..
Pipe tap chart below .
For instructions on how to add to our community's blog post, please visit our Get Involved page by clicking on the link above!
Steam Car Network functions as a resource for all steam car and steam bike enthusiasts. The website is constantly updated with articles, events, and informative posts to keep the community alive and growing. Feel free to contact us if you have any questions or concerns at the email address below and we will promptly reply.