Stanley Engine Parts6/13/2016 Rolly Evans writes:
I am attaching the DXF file for the frame parts. Your water jet cutter can cut just the parts you want.If you only cut the hook up parts you can use ¾ 4140 plate if you want the complete frame parts use 7/8 4140 plate. I am also sending a photo of my pattern of the cyl heads. The ring at the end is to make a thread gauge. Rolly
0 Comments
Leave a Reply. |
For instructions on how to add to our community's blog post, please visit our Get Involved page by clicking on the link above!
Archives
November 2022
Categories
All
|