2/28/2014 Gunnar Modig Jo... en liten uppgradering om vårt renoveringsprojektet, den gamla Mobilen. Nu är det ångförsörjning till maskinen som står på tapeten. På bilden syns från vänster först den så kallade trottelventilen. Därefter kommer två säkerhetsdetaljer som ej är original. först en huvudavstängning av ångan till maskinen. Just denna detalj saknades på de allra första modellerna vilket var lite opraktiskt om trottelventilen inte höll helt tätt, bilen kunde i värsta fall skena. Efter (eller flödesmässigt före) huvudavstängningen kommer ett T-rör som heller ej är original, dit skall en ny större säkerhetsventil anslutas. Detta är ett krav från den besiktningsman vi tar råd ifrån, i original sitter övertrycksventilen monterad på ett rör som är ca 10 mm utvändigt, detta är inte acceptabelt enligt dagens sätt att se på säkerhet. Ja sedan saknas bara en kort rörstump som ansluts mot utloppet i pannan. 2014-03-03 13:13 Gunnar Modig Trottelventil = ventilen som styr ånga till maskinen, eller gaspådrag om man säger så. Det framkommer inte så tydligt av bilden, men det går ett U-format rör mellan trottelventilen och inloppet till maskinen, detta för att få en flexibel överföring mellan pannan som sitter fast i karossen och ångmaskinen som måste kunna röras fram och tillbaka (det är så man sträcker kedjan). Gunnar Modig
Well ... a small upgrade of our renovation project, the old cell phone. Now it is steam, the machine is standing on the wallpaper. The photo shows from left only the so-called throttle valve. Then the two security features that are not original. First a main shutoff of the steam to the machine. This particular detail was missing on the first models which was a bit impractical if the throttle valve is not held tightly, the car could at worst rail. After (or flow rate before) main valve, a T-piece which either is not original, there should be a new, larger safety valve connected. this is a requirement from the expert we take advice from, the original is the pressure relief valve mounted on a pipe that is about 10 mm outside, this is not acceptable in today's approach to security. Yes, then missing only a short piece of pipe connected to the outlet on his forehead. 2014-03-03 13:13 Gunnar Modig throttle = valve that controls the steam machine, or throttle, so to speak. It appears not so obvious from the picture, but there is a U-shaped tube between the throttle valve and the inlet of the machine, in order to get a flexible transfer between the boiler attached to the body and the steam engine that must be moved back and forth (this is so stretching the chain).
0 Comments
|
About GunnarI am a self-taught steam car engineer whose interest is in the renovation, repairs and manufacturing of steam car parts.... Archives
July 2019
Categories |